Niles Audio HDL-6 Manuel d'utilisateur télécharger pdf (Page 11)

IGH

EFINITION

PEAKER

ELECTION

YSTEM

3. Make the connections to the HDL-6. The amplifier/speaker

connectors on the HDL-6 are removable. If you wish, you

may remove these connectors to facilitate installation.

(See

Figure 3)

. Strip 3/8" of insulation from the end of each wire.

Tightly twist the end of each wire until no frayed ends

remain. Insert each wire into the appropriate hole on the

spring-loaded connector terminals. Observe proper phasing

— connect the positive terminals on the HDL-6 to the

positive terminals on the amplifier and speakers, and the

negative terminals on the HDL-6 to the negative terminals on

the amplifier and speakers. If the connectors were removed,

reinstall them.

(See Figure 4).

4. Locate the pre-printed room labels. Affix the appropriate

label to the recessed area over each ON/OFF selector button.

Figure 3

Removing the Connectors

Figure 4

Installing the Connectors

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Niles Audio HDL-6 Manuel d'utilisateur Page 11